FlyingCam assembly
Parts needed
- Ikea NÄVLINGE lamp
- Seeed Studio XIAO ESP32S3 Sense
- Camera with long cable, preferably the ov3660
- 3D printed parts(Downloads):
- FlyingCam-esp32s3-top-cube
- FlyingCam-esp32s3-top-camholder
- FlyingCam-top-switch-holder
- powerbank-mount-bottom
- powerbank-mount-powerbank-spacer
- powerbank-mount-switch-holder
- powerbank-mount-top
- White round USB-Power Bank 5000mAh (like this one)
- When using internal fan:
- Small fan 40x40x10 mm
- FET IRLU024Z (or similar type)
- Resistor 150 ohms
- Resistor 10k ohms
- 2 switches 20x5mm (like this one)
- Zip tie for fixation of the Seeed module
- Wifi antenna with cable
- USB-A to USB-micro-B cable (male-female)
- USB-A cable/connector
- Power connector like on the Ikea power supply
Pinout Seeed module
- Fan D8 - GPIO7
- AP switch D9 - GPIO8
- 3V3 to AP switch
- GND to Power-connector(cut pcb piece), AP switch and Fan-FET
- 5V to Power-connector(cut pcb piece)
Take the pcb out of the LED-bulb and cut it near the bottom so that only the connector is left. Then cut the plastic case of the bulb near the bottom at the connector(the thread must be still on the connector), so that it fits like shown below:
If using a fan connect it like this:
Connect the USB output of the Power Bank to the power-connector of the lamp via the switch and the input of the Power Bank to the usb-jack in the foot. Drill a hole into the foot directly above the connectors for the wires.
Standmon assembly
Parts needed
- ESP32 8048S070 display
- 3D printed parts:
- standmon-7-back
- standmon-7-front
- 2X standmon-7-switch-holder
- Intenso Power Bank XS10000
- 2 zip ties
- 2 switches 20x5mm (like this one)
- short USB-C cable (male-female)
- USB-A cable/connector
- Screw M4x45
- 8x Screw M3
Disclaimer: Building and using FlyingCam and Standmon is on your own risk, no warranties of any kind are made.